I recently posted about how I had the privilege of studying a screen-used Worf TNG jumpsuit, courtesy of Angelo Cifaldi.
In addition to thoroughly documenting the costume’s dimensions and construction, I actually extrapolated a sewing pattern from it, using a technique I learned from a book called 101 Sewing Secrets from the Singer Sewing Reference Library.
Basically, this process entails pinning or hand-basting a layer of muslin to the garment and lightly tracing the seam lines (etc.) with a pencil.
I did this for all of the jumpsuit body panels!
I then transferred my muslin pattern to my dot-and-cross pattern-drafting paper, “true-ing” all the seam lines with the various rulers needed and double-checking everything for accuracy.
Then, I added all the corresponding seam/hem allowances to the appropriate edges and traced the pieces onto the large sheets of paper I usually use for my Tailors Gone Wild sewing patterns.
I’ve since had it scanned at my local copy/print shop, given it a good polish, and digitally labeled it, so it’s all ready to go!
You can download my traced pattern here for free.
The pattern is a PDF, comprised of three large pages.
All three pages are 36″ x 48″.
Click here for instructions for how to print a digital pattern download. 🙂
A few notes on the pattern draft:
- Keeping in mind that these jumpsuits were basically skin-tight, the finished garment measurements for this jumpsuit are: 46” chest, 37 ½” waist, and 45 ½” hips. According to Google, Michael Dorn is 6’ 3” tall.
As you may recall from my costume examination, some of the specific seam lines were slightly asymmetrical (e.g. shoulder seams, armscye seams, etc.). I took the liberty of making these seams symmetrical – both for my convenience, and for yours. 🙂
The seam allowances on the screen-used jumpsuit varied in a few places (e.g. the front upper/lower yoke seams), but I standardized them all. The neckline, upper/lower yoke, and front crotch seam allowances are ⅜”; the center front/zipper, side, and inseam allowances are ⅝”; all other seam allowances are ½”.
- This traced pattern is VERY close to the original, but you’ll want to allow a tiny margin (say, about ⅛” in any given direction) for “human error.”
Here’s a comparison between the screen-used Worf season one jumpsuit, and a replica I made in the season two gold color using this extrapolated pattern I’m sharing:
I do hope you enjoy the free pattern. 🙂
FYI, this Worf uniform was one of the primary bases I used for my graded Tailors Gone Wild men’s TNG jumpsuit pattern.
If you appreciate this pattern download and would like for me to provide more of them, please support my costume research on Ko-Fi.
Every bar of gold-pressed latinum goes toward producing more sewing/costuming resources like this, for everyone interested in Star Trek costumes. 🙂
